9/10/2023 0 Comments Plastic wood puttyThis warranty is not transferable except that if a contractor purchased and applied the product to the property for you, then the warranty is transferable to you. This warranty is made to you, the product purchaser who owns the property where the product is applied. It is unlikely that exact color match to the original wood will be achieved. This product absorbs stain differently than wood. ![]() To stain wood filler, see directions inside cap sticker. Wait at least 30 minutes to sand, plane, or file. NOTE: Once Minwax® High Performance Wood Filler has hardened, then it can be painted or stained. After approximately 20 minutes, the repair should be hard enough to be carved and shaped using a sharp modeling knife.(Note: To fill deep holes, spread on 1/8 inch thin layers one at a time until the hole is filled.) Slightly over-fil to allow for sanding down. Work quickly since the mixture remains workable for about 10 minutes at room temperature. Spread on a thin layer followed by a sufficient amount to fill the gap. Apply the mixture immediately to the area to be repaired, using a plastic putty knife.Mix only as much as can be used in 15 minutes. Mix thoroughly for approximately 30 seconds or until you no longer see the white color of wood hardener. Depending on the size of the wood repair, scoop desired amount of wood filler from the can into the plastic lid and squeeze in a small amount of wood hardener from the tube, using approximately a 16:1 ratio of wood filler to wood hardener.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |